Homeowners may not realize that one third of their annual energy costs results from the constant use of their water heater. Updating a conventional water heater to a newer design that is more efficient may be an option. However, the costs of installing a new unit may be too expensive. This means existing units need to be properly maintained so they can run efficiently. Homeowners can follow a few tips to keep their unit maintained before calling a professional for Midland water heater repair.
Flushing the Unit
Sediment can build up in a water heater over time and cause the unit to lose efficiency. The sediment in the tank can also lead to a clogged water line and other plumbing problems. One of the main reasons to flush a water heater is to keep the unit running efficiently. This needs to be done once each year. If the water heater in a home is not running efficiently, then utility bills often increase.
The process of flushing a water heater involves a couple of steps. Turning off the supply of water to the unit is the thing to do. The next step is to connect a garden hose to the drain valve. Run the hose over to a nearby drain, put it in a large bucket, or take it outside. Open the drain valve to begin draining the tank.
Adjust the Temperature
The temperature of a water heater will need to be a minimum of 120 degrees for a residential home. This is the minimum temperature needed for washing dishes and clothes. If the temperature is too high, then the unit is using too much energy to heat the water. Changing the temperature is done by adjusting the thermostat.
Adjusting the thermostat is done by first opening the access panel. However, this should be done when the unit is turned off. This is only needed if the unit is electric. A panel on the side of the unit needs to be removed to access the thermostat. Turn the dial of the thermostat with a screwdriver until it is set at the desired temperature. If the water heater is a gas unit, then the thermostat in on the outside of the tank.
Relighting the Pilot
Gas water heaters have a pilot light that may occasionally go out and need to be reignited. This is done by first removing the access panel cover. Lifting up the heat shield will show a homeowner if the pilot light it lit. If the pilot light is not lit, then turn off the gas to disperse any lingering fumes. Resetting the pilot light is done with a match or lighter and by pressing the reset button on the control box.